Cold mosaic material (acrylic cold mosaic material)
Features:The product is refined from imported raw materials. In the production process of printed circuit boards, in order to monitor the thickness of the plating layer in the PTH hole, the etching rate of the line etching, etc., metallographic microscopic analysis must be carried out. It is a special chemical product for metallographic slicing and molding with acrylic resin as the main raw material. It has excellent properties such as stable and fast curing at room temperature, few bubbles, long-term storage without discoloration, high hardness, and acid and alkali resistance.
Unique advantages:
1. Fast curing, stable and high transparency
2. Low viscosity, excellent flow performance
3. Excellent permeability to small holes and depressions
4. After the slice is cured, it has a good support for the slice
5. After the slice is cured, it has sufficient hardness and toughness
6. The slice has sufficient brightness after polishing
7. Very low shrinkage before and after curing
Instructions:
Mix the acrylic powder with the curing agent at a ratio of 1.4: 1 (volume ratio), and slowly stir (to avoid the generation of artificial bubbles) into the mold, wait for it to fully cure, the curing time is about 10-15min This product contains a defoamer. If used properly, there will be no bubbles.
Product packaging:
1kg acrylic powder + 800ml curing agent
